Télécharger Imprimer la page

HP Photosmart C5200 Serie Guide D'utilisation page 22

Masquer les pouces Voir aussi pour Photosmart C5200 Serie:

Publicité

Les langues disponibles

Les langues disponibles

Chapter 2
Try connecting the USB cable to another USB port on your computer. After you check the
connections, try restarting your computer. Turn the HP All-in-One off and then on again.
If the HP All-in-One is offline, turn the HP All-in-One off and on again. Start a print job.
If necessary, remove and then install the software you installed with the HP All-in-One again.
For more information on setting up the HP All-in-One and connecting it to your computer, see
the Setup Guide that came with the HP All-in-One.
Clear paper jams
If the HP All-in-One has a paper jam, check the rear door.
To clear a paper jam from the rear door
1.
Press in the tab on the left side of the rear door to release the door. Remove the door by pulling
it away from the HP All-in-One.
CAUTION:
print mechanism. Always access and clear paper jams through the rear door.
2.
Gently pull the paper out of the rollers.
CAUTION:
and wheels for torn pieces of paper that might be remaining inside the device. If you do not
remove all the pieces of paper from the HP All-in-One, more paper jams are likely to occur.
3.
Replace the rear door. Gently push the door forward until it snaps into place.
4.
Press OK to continue the current job.
CD/DVD print troubleshooting
Use this section to solve any problems you might encounter while printing on CD/DVD surfaces with
the HP All-in-One.
The HP All-in-One does not detect the CD/DVD holder
Cause: You might not have pushed the CD/DVD holder far enough into the CD/DVD tray.
Solution: Push the CD/DVD holder forward into the CD/DVD tray until the lines on the holder
line up to the white lines on the tray. The end of the holder marked with arrows goes into the
CD/DVD tray first.
22
HP Photosmart C5200 All-in-One series
Trying to clear a paper jam from the front of the HP All-in-One can damage the
If the paper tears when you are removing it from the rollers, check the rollers

Publicité

loading