Seca 704s Mode D'emploi Et Garantie page 30

5.2 Fit column
Assembly
bores
5.3 Fit measuring rod
173 cm
30 •
All manuals and user guides at all-guides.com
1. Place the column on the weighing platform as
shown in the adjacent illustration:
– the display head points away from the
– assembly bores for the measuring rod point
2. Perform all the remaining assembly steps for the
column as described in the instructions for use for
the
seca 704/703
►
►
►
3. Set up the scale as described in the instructions for
use for the
4. Provide the power supply for the scale as de-
scribed in the instructions for use for the
.
703
1. Pull out the upper telescopic element as far as the
173 cm mark.
The assembly bores in the lower telescopic element
are exposed.
2. Align the measuring rod as shown in the adjacent
illustration.
3. Put a set screw in the upper bore of the measuring
rod.
4. Align a spacer sleeve as shown in the adjacent
illustration.
5. Put the spacer sleeve on the set screw.
6. Screw the measuring rod hand-tight to the column
using the upper set screw.
7. Repeat steps 3. to 6. for the lower set screw.
8. Tighten up both set screws firmly.
platform
towards the weighing platform
:
Screw column tight
Connect display cable
Connect the power supply cable to the
electronics box
.
seca 704/703
seca 704/