KitchenAid Artisan 5KSM125 Manuel D'utilisation page 15

USING THE STAND MIXER
BEATER TO BOWL CLEARANCE
Your Stand Mixer is adjusted at the factory so the flat beater just clears the bottom of the
bowl. If, for any reason, the flat beater hits the bottom of the bowl or is too far away from
the bowl, you can correct clearance easily.
Turn speed control to "0". Unplug
1
Stand Mixer.
NOTE: When properly adjusted, the flat
beater will not strike on the bottom or
side of the bowl. If the flat beater or the
wire whip is so close that it strikes the
bottom of the bowl, coating may wear off
the beater or wires on whip may wear.
W10863290A_01_EN_v06.indd 15
All manuals and user guides at all-guides.com
2
Lift motor head. Turn screw slightly
counterclockwise (left) to raise flat
beater or clockwise (right) to lower
flat beater. Make adjustment with
flat beater, so it just clears surface
of bowl. If you over adjust the screw,
the bowl lock lever may not lock
into place.
USING THE STAND MIXER | 15
3/30/16 11:18 AM