Triton T12OT Instructions D'utilisation Et Consignes De Sécurité page 11

Maintenance
• This tool is manufactured using class leading components and makes
use of the latest in intelligent circuitry that protects the tool and its
components. In normal use it should provide a long working life
Cleaning
• Keep your machine clean at all times. Dirt and dust will cause internal parts
to wear quickly, and shorten the machine's service life. Clean the body of
your machine with a soft brush or dry cloth. If available, use clean, dry,
compressed air to blow through the ventilation holes
Storage
• Store this tool and its accessories after use in its case, in a dry, secure
place out of the reach of children
Troubleshooting
Problem
Red LED does not
illuminate and Battery (5)
not charging
Battery has low capacity
Tool cannot be switched on
Tool stops operating
during use
Blade not cutting correctly
Sanding sheets come loose
from sanding pad in use
GB
Unknown mechanical noise
Burning smell or other
abnormal operation
10
350766_Z1MANPRO1_NEW_V2-USA.indd 10
Possible cause
Battery not fully seated
Battery Charger (11) not powered
Battery not being fully charged
Battery has been charged over 100 times and capacity has
started to reduce
Battery discharged
Defective battery
Tool defective
Battery has low charge
Over temperature safety feature has operated
Over current safety feature has operated
Speed setting low
Material may not be suitable for blade
Material not suitable for tool
Blade may be worn
Speed set too high
Too much downward pressure in use
Hook and loop fastenings worn on pad
Accessory not securely fitted
Tool fault
Tool fault
Disposal
Always adhere to national regulations when disposing of power tools that are
no longer functional and are not viable for repair.
• Do not dispose of power tools, batteries or other waste electrical and
electronic equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools and batteries
Solution
Refit Battery correctly
Recheck mains connection
Wait until Green LED is illuminated
This is normal for batteries. Contact your Triton dealer to
purchase a replacement battery
Recharge battery or replace with a charged battery
Replace battery
Contact your Triton dealer or authorised service centre
Charge battery fully before use especially before jobs that are
more difficult to cut
Tool may require up to 30 minutes for tool to reset. A slower
speed setting may be required to prevent this safety feature
operating. Check Motor Vents (2) are not blocked. Reduce
the amount of hand pressure on the tool to reduce load on
the motor
Tool may require up to 1 minute to reset. A slower speed
setting may be required. Check Motor Vents are not blocked.
Reduce the amount of hand pressure on the tool to reduce
load on the motor
Increase speed
Change blade
Some materials including hardened metals have no
compatible blade
Replace blade
Reduce speed
Reduce hand pressure
Replace sanding pad
Check blade or other accessory is securely tightened
Stop using the tool and contact your dealer or authorised
Triton service centre
Stop using the tool immediately and contact your dealer or
authorised Triton service centre
26/09/2014 08:53