Fein KBM80U Mode D'emploi page 19

OBJ_BUCH-0000000008-002.book Page 19 Tuesday, November 17, 2015 11:24 AM
en Original Instructions for Core Drill.
Symbols, abbreviations and terms used.
Symbol, character Explanation
Do not touch the rotating parts of
the power tool.
General prohibition sign. This
action is prohibited.
Observe the instructions in the
text or graphic opposite!
Make sure to read the enclosed
documents such as the Instruction
Manual and the General Safety
Instructions.
Observe the instructions in the
text or graphic opposite!
Before commencing this work
step, pull the mains plug out of the
socket. Otherwise there will be
danger of injury if the power tool
should start unintentionally.
Use eye protection during opera-
tion.
Use ear protection during opera-
tion.
Confirms the conformity of the
power tool with the directives of
the European Community.
This sign indicates a possible dan-
WARNING
gerous situation that could cause
severe or fatal injury.
Worn out power tools and other
electrotechnical and electrical
products should be sorted sepa-
rately for environmental-friendly
recycling.
Ø Diameter of a round part
1st gear/2nd gear/3. gear
Drilling capacity in steel - TCT
Fe HM
(core drill bit)
Drilling capacity in steel - high
Fe HSS
speed steel (HSS) (core drill bit)
Symbol, character Explanation
Drilling capacity in steel - high
speed steel (HSS) (twist drill bit)
Tap
Max. twist drill bit diameter with
the supplied chuck
Reamer diameter
Counterboring diameter
Weight according to EPTA-
Procedure 01
Low speed
High speed
Magnetic holding power, sufficient
Magnetic holding power, insuffi-
cient
Switches the cooling-lubricant
flow on/off
Starts the drill motor. Rotation
direction: clockwise
Starts the drill motor in inch
mode. Rotation direction: anti-
clockwise
Speed reduction in steps
Stops the motor
en
19