Voltage Selector - VINCENT SV-227MK Manuel D'utilisation

13
11. INPUT: S3 - S6
Here you can connect up to four source devices
with stereo audio line level output.
12. SPEAKER A/B: Speaker connectors
Output sockets with screw clamps for connection
of two pairs of loudspeakers. You can use loud-
speaker cables with 4 mm banana connectors.
13. REC OUT: Recording output
If desired, you can connect a recording device like
a CD recorder or a tape recorder to this output. The
stereo signal of this output is identical to the output
signal of the selected audio source at one of the
inputs (11). It is independent of the volume setting
(3)(21), the Tone control (5)(6)(8), the Loudness set-
ting (9), the setting of the Speaker switch (4) and the
plugging-in of a headphone (10).
14. PRE OUT: Preamplifier output
With these two pairs of connectors you can con-
nect the preamplified stereo audio signal of the
currently selected source to additional power
amplifier channels or an active subwoofer. The
signal of this output is independent of the "SPEA-
KER A/B" setting (4) and the plugging-in of a
headphone (10).
Vincent
30
REAR VIEW
11 15
14 16
12
17
15. DIGIT L IN: Optical/Coaxial
Connections for audio signals of source devi-
ces with digital sound such as, for example,
DVD players. "Optical" for optical fibre con-
nection and "Coaxial" for connection via coa-
xial cable.
16. AC 220-240V: Mains connector
To establish the power supply, connect the plugs
of the power cable to the device and to a suitable
wall outlet. The small plastic housing holds the
fuse. Refer to the security precautions.

17. Voltage Selector:

The voltage selector behind the pane allows swit-
ching the voltage from 230 V to 110 V.
Refer to safety instructions for further information
(p. 37, "Switching the Voltage")
18. POWER CONTROL (12V)
These jack connectors (3.5 mm) send the signals
for the standby control (12V Trigger).
18