Voltage Selector - VINCENT SV-237MK Manuel D'utilisation

14
12
12. REC OUT: recording output
If desired, you can connect a recording device
like a CD recorder or a tape recorder to this out-
put. The stereo signal of this output is identical to
the output signal of the selected audio source at
one of the preamplifier INPUTs. It is independent
of the volume setting (5)(23), the Tone Control
(1)(2)(6) and the loudness setting (10). As long as
the preamplifier is muted (20), the "OUTPUT REC"
does not provide the music signal.
13. PRE OUT: preamplifier outputs
With this pair of RCA connectors you can output
the preamplified stereo audio signal of the cur-
rently selected source to power amplifier channels
or an active subwoofer.
14. INPUT: input connectors
Here you find six stereo RCA inputs for the source
equipment with analogue stereo (line level) audio
output.
15. DIGIT L IN: Optical/Coaxial
Connections for audio signals of source devi-
ces with digital sound such as, for example,
DVD players. "Optical" for optical fibre con-
nection and "Coaxial" for connection via coa-
xial cable.
30
Vincent
REAR VIEW
15
13
16
18
19
17
16. AC 220-240V:
Power Connector with Fuse holder
To establish the power supply, connect the plugs
of the power cable to the device and to a suitable
wall outlet. The small plastic housing holds the
fuse. Refer to the security precautions.
17. POWER CONTROL (12V) OUTPUT
At these jack connectors the signals for the on/off
control (Power Control, Trigger) are emitted.
18. SPEAKERS: Speaker connectors
Output sockets with screw clamps for connection
of one or two pairs of loudspeakers. You can use
loudspeaker cables with 4 mm banana connec-
tors. Please refer to the precautions in the section
"Installation" in case two pairs of loudspeakers
are connected.

19. Voltage Selector:

The voltage selector behind the pane allows swit-
ching the voltage from 230 V to 110 V.
Refer to safety instructions for further information
(p. 36, "Switching the Voltage")