VINCENT SV-227MK Manuel D'utilisation page 41

One special feature of this amplifier is the option to connect two pairs of loudspeakers and to turn them
on or off individually by means of a switch on the front (4). This can be used to activate and deactivate
the music playback to both places where the pairs of loudspeakers are set up in any desired combination
(only A, only B, A and B together or both switched off) without having to pull out the loudspeaker cables.
If you intend to connect two pairs of speakers, all loudspeakers must have a nominal impedance
of at least 8Ω. If only one pair of speakers is used (A or B), all types of loudspeakers with a mini-
mal nominal impedance of 4Ω can be utilised.
Consider correct polarity, the positive contact is mostly marked red or with "+". The side of the
speaker cable that has to be connected with the positive socket has a marking.
CONNECTION OF THE POWER CABLE
Check that the electricity supply to your home is appropriate to the device. The required voltage and fre-
quency can be read on the back of the device beside the socket for the mains. If the electricity supply is
appropriate, push the inlet connector of the supplied mains cable firmly into socket for the mains on the
back of the device (15). Connect the other end of the mains cable to a mains socket.
Vincent
41