Tecno-gaz Astra 3S Mode D'emploi page 16

Cleaning temperature symbol (degrees centigrade)
Fig. 4 Rear side view of the ASTRA units
Unit rating plate.
12
Socket.
Chapter 3
WORKING INSTRUCTIONS FOR MODELS IN THE S SERIES (see Fig.1)
1) To switch on the unit rotate the Timer/Switch knob clockwise ( ) and set the required cleaning time.
2) At the end of the time set the machine will switch off automatically. If operation of the machine is to be interrupted at
any time, return the Timer/Switch knob to the "0" setting.
3) In order to set a cleaning time longer than 15 minutes, rotate the Timer/Switch knob anticlockwise. In this way the clea-
ning time can be set by hand, and the unit switched on or off according to needs (see Fig. 3).
4) In order to actuate heating with thermostat control at 60°C, press the illuminated button marked Heater ( ).
5) After the washing cycle, in order to de-actuate heating, press the Heater switch ( ).
WORKING INSTRUCTIONS FOR MODELS IN THE D SERIES (see Fig. 2)
1) To switch the unit on or off press the main switch ( ).
2) After the main switch has been pressed, the green ON pilot light ( ) and that of the 40°C temperature button will light
up. The 40°C temperature button pilot light will light up each time the main ( ) switch is pressed as the microproces-
sor always sets the lowest temperature and the shortest cleaning time (in any case, in order to start the cleaning cycle
or switch on heating, the ( ) "
3) Press one of the buttons for 5-10-15 minutes according to needs ( ).
4) In order to start or stop the cleaning cycle press the "
for the time you have set. At the end of this time the machine will stop automatically.
5) To double washing times and to obtain washing timing of 10-20-30 minutes, press the minutes key ( ) twice corre-
sponding to the time you require (within a maximum interval of 5 seconds). The machine will give a double Beep to
confirm that double pressing of key ( ) has been correctly set. Press the " Start/Stop" ( ) "
the washing cycle. Note: If you have set double washing times, the machine will give a double Beep after pressing the
key ( ) before the washing cycle starts.
9
HOW TO REGULATE THE CLEANING TEMPERATURE (see Fig. 2)
1) Before switching on the heating check that there is liquid inside the tank and that the level is not below 4 cm from the
upper edge. If the heating is switched on without liquid, there is the risk of burning the resistor and damaging the enti-
re unit.
2) Set the required temperature of the washing dip by pressing one of the three buttons: 40°-50°-60°C ( ). On pressing
one of the three buttons, the pilot light corresponding to the temperature button set will light up.
3) In order to switch on the resistor press the heating ( ) "
4) On the control panel the red heating pilot light ( ) marked by the symbol
this means that the resistor is in operation and that the liquid is heating. When the pilot light goes out this means that
the resistor is no longer in operation since the liquid has reached the temperature set previously.
Note:
Whenever a button of the membrane pushbutton panel of the control panel is pressed, a beep is heard which confirms
pressing of the button.
When the heating function is enabled with temperatures higher than 50°C, do not
place your hands in the washing liquid. Risk of scolding and burns. Use gloves and
adequate means of protection.
5
" and ( ) " " buttons must be pressed.
8 9
10
8
6
WARNING
2
1
11
6
10
" button ( ). In this way the cleaning cycle will be started
9
" button. The corresponding pilot light will light up.
will also light up. If the pilot light is on,
1
10
" key to start or stop
9
7
17