Pfannenberg Quadro LED-HI-3G Instructions De Service page 14

en
6.2 Assembly and installation
➢ Observe the
Safety
➢ Observe nationally applicable installation regulations for all work.
Installation requirements:
➢ Install the devices in compliance with the current editions of the relevant parts of EN 60079 or equivalent
IEC specifications.
EN 60079-10-1 Potentially explosive atmospheres - Part 10-1:
Classification of areas subject to gas explosion
EN 60079-10-2 Potentially explosive atmospheres - Part 10-2:
Classification of areas subject to flammable dust
EN 60079-14 Potentially explosive atmospheres - Part 14:
Project planning, selection and installation of electrical systems
Minimum requirements for cable glands:
Ex-e cable gland for a permissible temperature range from -20°C ... +85°C, equipped with an O-ring and pro-
tection type IP 66/67. A long connection thread is necessary >12mm.
Cable glands of the following types have been tested to ensure that the housing is vapor-proof under continu-
ous use:
Hummel HSK-K-Ex-Active, M20x1,5, EC type-examination certificate BVS 14 ATEX E 025 X:
– Sealing range 7 – 12 mm,
– Sealing range 10 – 14 mm,
The sealing screw can be replaced by the cable glands specified above.
Note for the selection of the connection cable:
The temperature of 70°C is not exceeded at the cable inlet point.
➢ Protect connection cables against pulling and twisting.
Installation:
➢ Loosen the four cross-head screws in the lens and remove them upwards.
The holes for mounting the housing are then accessible, for dimensions see chapter
ternative installation possible with the brackets supplied.
➢ Perform electrical connection on the circuit board in the lens as follows:
AC version
X1
09/2022
Quadro LED-HI-3G/3D Operating Instructions
information!
Hummel type No.: 1.292.2016.31 (factory assembled and tested)
Hummel type No.: 1.292.2016.30
Light intensity
control
(15 – 100 %)
Connection of
the line
S1
Selection of operating mode
S1
ing mode
1 2 3
OFF OFF OFF
OFF OFF ON
OFF ON OFF
OFF ON ON
ON OFF OFF
ON OFF ON
ON ON OFF
ON ON ON
* Factory setting
Page 6 / 8
3. Dimensions.
Operat-
no.
Flashing light
1
Hz
2
Flashing light
3 Continuous light
4 Blinking light
5 Flashing light
6 Blinking light
7 Flashing light
8 Flashing light
Al-
0.75
*
1 Hz
1 Hz
2 Hz
2 Hz
0.1 Hz
0.5 Hz
086200013b