Publicité
Les langues disponibles
Les langues disponibles
en
5. Conformity to standards/ designations
Conformity to standards:
(Explosion protection)
Designation
PDG 19.0007 X
Special application conditions X
The device is suitable for a low degree of mechanical hazard in accordance with the requirements of
EN IEC 60079-0. This means:
➢ The device must be mounted protected against impact.
A protective basket is not absolutely necessary.
Refer to the
Safety information
from the housing surface in potentially explosive gas atmospheres:
➢ The device must only be wet-cleaned.
➢ Avoid unintentional and dry rubbing.
➢ Prevent touching with insulating objects.
An installation height of > 2.50 m or comparable protective measures is therefore suggested.
➢ Protect the device from direct air streams. This could lead to a transmitted charge.
The device is designed for connection to permanently installed connection cables. The cable glands are suita-
ble for stationary cables and wires.
The device is usually not intended for opening after installation.
If it should nevertheless become necessary to open the device (e.g. to change the operating mode or replace
original spare parts):
➢ Observe the
Safety
➢ Observe chapter
7. Maintenance, service, repairs!
09/2022
Quadro LED-HI-3G/3D Operating Instructions
Directive 2014/34/EU (ATEX)
EN IEC 60079-0
EN 60079-15
EN 60079-31
II3G Ex nR IIC T6 Gc
II3D Ex tc IIIB T80°C Dc IP66/67 (-20°C Ta +55°C)
in the operating manual to prevent possible hazardous electrostatic discharges
information!
(-20°C Ta +55°C)
Page 4 / 8
086200013b
Publicité
