Puky CAT 1SP Mode D'emploi page 10

CAT – Tricycle CAT – Driewieler
Figure 12: (only CAT 1SP) Pull the attached
belt first through the footrest and then through
the belt latch.
Figure 13: (only CAT 1SP) Stick the footrest
onto the pedals and attached the belt on the
frame.
When­using­the­footrest,­the­freewheel­hub­
must­be­switched­on­(pull­catch­ring­away­
from­the­rim.)
Operation
Figure 14: Disable the freewheel hub so that
the child can pedal by him/herself. To do this,
press the catch ring against the rim until it
snaps into place. Slightly turn the pedal to
make it easier to snap the catch ring into
place.
Figure 15: Turn the knob 90° to enable or
disable the steering lock.
Figure 16: The seat position can be continu-
ously adjusted by slightly loosening the screw
connection.
Afterwards,­twist­the­screw­connection­
back­on­and­tighten­sufficiently.
Figure 17: Set the height of the push bar by
pressing the catch (spring.)
Make sure that the catch (spring) snaps
back­in­correctly.
Figure 18: To remove the push bar: unscrew
the safety lever, push the catch (spring) and
pull the bar out.
Figure 19: (only CAT 1 SP) The net can be
removed by pulling it out of the clip on the
trough.
Figure 20: (only CAT 1SP) To use the shovel,
pull the push bar apart, and snap on the shov-
el.
10