Cleaning And Maintenance; Recommendations For Cleaning And Maintenance; Routine Maintenance; Faults - Sagi FERMA LIEVITA Manuel D'installation, D'utilisation Et D'entretien

ENGLISH
metal tools that may damage the condenser
fins.
 Check the planarity of the appliance rest
surface.
 Do not introduce liquid or solid substances at
temperatures
temperature and, however, introduce the
material after the appliance has reached the
functioning temperature.
6.

CLEANING AND MAINTENANCE

6.1.

Recommendations for Cleaning and Maintenance

!
GB
Before
intervention,
devices. In particular, deactivate the electrical
6.2.

Routine Maintenance

Routine maintenance consists of daily cleaning of
all the parts which can come into contact with
foodstuffs and the periodic maintenance of the
burners, nozzles and draining pipes.
Correct maintenance allows the user to maximise
performance
constantly maintain safety requirements.
Do not spray the appliance with direct jets of
water or high pressure appliances.
When cleaning stainless steel, do not use iron
wool, brushes or scrapers as ferrous particles
could be deposited which, on oxidising, could lead
to rust.
To remove hardened residues, use wooden or
plastic spatulas or abrasive rubber pads.
During long periods of inactivity, spread a
protective layer on all stainless steel surfaces by
wiping them with a cloth soaked in Vaseline oil
and airing the rooms periodically.
7.

FAULTS

The information shown below aims to help with
the identification and correction of any anomalies
and malfunctions which could occur during use.
Some of these problems can be resolved by the
above the environmental
carrying out any maintenance
activate all envisioned
levels and operating
 Do not stack the materials to be preserved in
contact with the internal walls, so blocking the
circulation of air, which guarantees uniformity
of the internal temperature of the refrigerated
compartment.
 Limit the number of times and the duration of
time the doors are open to a maximum.
power supply using the automatic disconnecting
switch.
safety
!
Do not use products which contain
substances which are harmful and dangerous for
personal health (solvents, petrol etc.).
life and
Periodically have the following operations carried
out by specialised staff:
 Periodically clean the condenser using
suitable tools (suction device or soft
brushes).
 Check the perfect sealing of the door
gaskets and replace them if necessary.
 Periodically
evaporation tray.
 Check that the electric connections have
not loosened.
 Check the efficiency of the heating
element (in BT models).
 Check functioning of the electric boards
and probes.
 Check the efficiency of the electrical
system.
user. For the others, precise competency is
required and they must therefore only be carried
out by qualified staff.
18
clean the condensate