Recommendations For Use - Sagi FERMA LIEVITA Manuel D'installation, D'utilisation Et D'entretien

If the key is pressed, access is gained to the
inputs and
SET UP 02
Inpunts/Outputs
mode.
Using the keys, scroll the sizes to be
displayed:
Cell
Evap -15°C
Humidity
C D E R V H U
1 0 0 1 1 0 0
DI1 DI2
0 1
Where:
 Cella (Cell)
Temperature read by the probe
cell
 Evapor
Temperature read by the
evaporator probe
Settings 03: Restore Original Parameters
If key is pressed, access is gained to the
request to restore
SET UP
Reset
parameters.
5.4.

Recommendations for Use

Prolonged Inactivity
If the appliance remains inactive for a long period,
proceed as follows:
1. Use the automatic disconnecting switch to
deactivate connection to the main electrical
line.
2. Clean the appliance and surrounding areas
thoroughly;
3. Spread a thin layer of cooking oil onto the
stainless steel surfaces;
4. Carry out all maintenance operations;
5. Leave the doors ajar to prevent the formation
of mould and/or unpleasant odours.
outputs display
-6°C
80%
FAN
90
=
=
the original
03
 Umidità (Humidity)
read by the humidity probe
 C
the Compressor outlet
deactivated 1=relay activated)
 D
the Defrost outlet
deactivated 1=relay activated)
 E
the Electric valve / Light outlet
(0=relay deactivated 1=relay
activated)
 R
the Resistance outlet
deactivated 1=relay activated)
 V
the Fan Evaporator outlet
deactivated 1=relay activated)
 H
the Steam generator outlet
deactivated 1=relay activated)
 U
the Injection Valve outlet
deactivated 1=relay activated)
 DI1
the digital inlet 1
active)
 DI2
the digital inlet 2
active)
 FAN
speed in percentage.
Pressing key
restoring being performed.
Pressing key
parameters.
Restore ?
No
6. Empty the water present in the vapour
generator boiler after having removed the
clamp
Recommendations for normal use
In order to ensure correct use of the appliance, it
is advisable to
recommendations:
 Do not obstruct the front and rear zones
above the condensing unit in order to favour
heat disposal from the condenser to a
maximum.
 Always keep the front of the condenser clean
using a soft brush and do not use rigid or
17
ENGLISH
= Value
= State of
(0=relay
= State of
(0=relay
= State of
= State of
(0=relay
= State of
(0=relay
= State of
(0=relay
= State of
(0=relay
= State of
(1=inlet
= State of
(1=inlet
= Fan
exits the menu without any
restores the default
OK
apply the following
GB