Safety Functions; Emergency Push-Button; Hood Safety Switch; Driver's Seat Microswitch - Nilfisk SR1000S P Instructions D'utilisation

SAFETY FUNCTIONS

The machine is equipped with the following safety functions.

EMERGENCY PUSH-BUTTON

It is located in an easily accessible position (8, Fig. B). It has
to be pressed in case of emergency, to stop all the machine
functions.

HOOD SAFETY SWITCH

It activates when the machine hood is opened: It stops all
functions.
If the machine keeps operating when the hood is open,
contact an authorised Service Center or Retailer immediately.

DRIVER'S SEAT MICROSWITCH

It is located inside the driver's seat and it does not allow the
machine drive system to operate if the operator is not seated
on the driver's seat.
146 1960 000(2)2006-06 A

TROUBLESHOOTING

TROUBLE
The engine does not start by
turning on the ignition switch.
The engine stops during
operation.
The side brooms do not rotate.
The machine does not move
by pressing the pedal (5, Fig.
C).
(1): For the procedure, see the Petrol Engine Manual.
For further information, refer to the Service Manual, available
at any Nilfisk-Advance Service Center.
USER MANUAL
REMEDY
Check the engine oil level (1).
Check if the fuel tap is open.
Check if there is fuel in the tank.
Check if the hood is closed.
Check if the fuel reaches the
carburettor (1).
Check if the spark plug produces a
spark (1).
Check the engine oil level (1).
Check if there is fuel in the tank.
Lower the side brooms.
Check the fuse F5 in the box (23,
Fig. U) for integrity.
Check that the parking brake (6
and 7, Fig. C) has been released.
Check that the switch (27, Fig. U)
is in "I" position.
Check that the drive pedal (5, Fig.
C) is not pressed while starting the
machine with the ignition switch (2,
Fig. B), or while the operator is
sitting on the driver's seat. The
drive pedal (5, Fig. C) has to be
pressed only after the operator has
sit on the driver's seat and the
machine has been started.
15