Amanngirrbach af350 Mode De Fonctionnement page 10

gB
make sure that the reason for the blockage has
been ascertained before switching the motor
back on.
aSSeMBly OF the MODellIng taBle
The patented MT3 modelling table has been
specifically developed for milling. The model is
fixed with the finger screw
ring downwards allows the MT3 to move freely.
CL
Activating the magnetic plate
its inclination and position. Switching the
magnetic plate
freely again. The MT3 can be locked in any
position mechanically using the screw on the side
of the appliance
locking. To unlock the table, open the screw
slightly and press it is; the MT3 can move freely
again. To return the MT3 into a definite position
(0 degrees), push the centring ring upwards.
acceSSOrIeS (p. 27)
Marking stick and adjustable adapter cable
The marking stick and the adjustable cable are
available as accessories for this appliance. To use
the marking stick, first remove the motor unit
with an Allen key, loosen the screw fixing the
motor to the milling arm, the motor removed and
the power cable at the spindle column unplugged.
The adjustable adapter cable consists of two
parts:
1. the adapter with temperature control;
2. the adapter cable. The marking stick is inserted
into the adapter, both together are inserted into
the milling arm and fastened with the Allen screw.
The adapter cable is plugged into the spindle
column and the spiral spring secured.
Blockout set B2
The set includes a heating element with a
connecting cable, five inserts and a key. Inserts
are shaped in 0°, 2°, 4° and 6°, with the 0° insert
available in two diameters (1.3 mm and 2.0 mm).
10
. Pulling the centring
BU
locks the MT3 in
@
off releases the MT3 to move
@
, even without magnetic
CM
To use the blockout set, the heating element is
attached to the lower part of the marking stick.
The inserts are attached to the heating element
by twisting, and the connecting cable of the
heating element is plugged into the adjustable
adapter cable. To release the insert, insert the
key between the heating element and the insert
and tilt downwards.
attentIOn: Check all plugs for proper
connections.
attentIOn
pull the plug!
Basically, the apparatus is maintenance-free.
Dirty marks should be cleaned dry. No steaming
and do not clean with water or solvents.
:
DM