EUROM Heat-Boost 1500 Manuel D'utilisation page 16

functioning as normal but, before reusing, switch off, unplug and check for damage. Do not
use the heater if it is damaged or malfunctioning, but have it inspected/repaired!
In case of internal overheating, the overheating safeguard will switch the heater off. This
may occur if the heater cannot give off enough heat or if it cannot draw in enough fresh air.
As mentioned above, this is generally caused by (partially) covering the heater, obstructing
the air intake and/or outlet grills or installing the heater too close to a wall or something
similar. When the heater has cooled down sufficiently, it will in principle start again
automatically, however if you do not remove the cause of the cut-off then this will probably be
repeated. Regular overheating can give rise to irreparable damage.
When the overheating safeguard switches the heater off, set the mode selector dial to 'OFF'
(off), unplug and allow the heater to cool down. Remove and/or amend the cause of
overheating and reuse the heater as normal. If you cannot find a cause and overheating
recurs, stop using the heater, and take it in for inspection/repair.
Cleaning and Maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common cause of
overheating so these should be removed regularly. Switch off the heater, remove the plug
from the socket and allow the heater to cool down before cleaning or carrying out
maintenance work.

Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use
aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or chemical solutions!

Using a vacuum cleaner, carefully remove any dust and dirt from the grills and ensure
that the air intake and outlet openings are clean. Be careful not to touch or damage any
internal parts during cleaning!

The heater contains no other parts which need maintenance.

At the end of the season, store the cleaned heater in the original packaging if necessary.
Store it upright in a cool, dry and dust-free place.

Do not dispose of heater with household waste when it becomes worn or
damaged beyond repair. Take it to your local authority's collection point for
electrical appliances where any reusable materials will be collected and
redistributed.
CE-statement
Euromac bv., Genemuiden-NL hereby declares that the EUROM fan heater with PTC-
elements, type Heat-Boost 1500, complies with the LVD guideline 2006/95/EC and the
EMC guideline 2004/108/EC (amended by 93/68/EEC) and meets the following standards:
EN 60335-1:2012+A11 :2014
EN 60335-2-30:2009+A11 :2012
EN 62233:2008
Blue Tooth :
EN 300328 V1.9.1
EN 301489-1
Genemuiden, 10-06-2015
W.J. Bakker, alg.dir.
-------------------------------------------------------------------------------------------------
EN 55014-1:2006+A1 :2009+A2 :2011
EN 55014-2:1997+A1 :2001+A2 :2008
EN 61000-3-2:2006+A1:2009+A2:2009
EN 61000-3-3:2013
EN 301489-17
EN 62479
16