Flex WST 700 VV Notice D'instruction D'origine page 24

WST 700 VV
As the triangular sanding head can revolve
on bearings, it can sand right into the corners
of the wall/ceiling.
In the corners reduce the contact pressure,
otherwise there will be excessive load on
the tips of the triangular sanding disc.
Heavily worn corners of the triangular sanding
head can easily be replaced.
Maintenance and care
t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâI=éìää=çìí=íÜÉ=ã~áåë=
éäìÖK=
Cleaning
t^okfkd>
aç åçí=ìëÉ=ï~íÉê=çê=äáèìáÇ=ÇÉíÉêÖÉåíëK
 Regularly blow out the housing interior
and motor with dry compressed air.
 Blow out the sanding head (sanding plate
and gimbal bearing) with dry compressed
air.
Replacing the sanding plate on the
round sanding head
 Take hold of the sanding plate together with
the sanding head housing to prevent the
sanding plate from turning.
 Unscrew the retaining nut on the sanding
plate in an anti-clockwise direction
and remove.
 Remove the sanding plate.
 Insert new sanding plate and secure with
the retaining screw.
Replacing the brush ring
 Remove the sanding plate (B) (see section
entitled "Replacing the sanding plate").
 Loosen the retaining screws (C).
 Take the ring (D) out of the housing.
 Insert a new brush ring into the housing
and screw in the retaining screws.
Attention:
The brush ring can be fitted in one position only.
Note recess on the springs!
 Re-insert the sanding plate (B).
Repairs
Repairs may be carried out by an authorised
customer service centre only.
klqb
aìêáåÖ=íÜÉ=ï~êê~åíó=éÉêáçÇ=Çç=åçí=äççëÉå=
íÜÉ ëÅêÉïë=çå=íÜÉ=ãçíçê=ÜçìëáåÖK=
kçåJÅçãéäá~åÅÉ=ïáää=ÇÉÉã=íÜÉ=Öì~ê~åíÉÉ=
çÄäáÖ~íáçåë=çÑ=íÜÉ=ã~åìÑ~ÅíìêÉê=åìää=~åÇ=îçáÇK
23