Tennant T3 Opérateur Manuel page 20

OPERATION
USING THE OFF- -BOARD BATTERY CHARGER
For battery charger operating instructions, refer to
the Battery Charger Manual supplied with charger.
1. Transport the machine to a well--ventilated area
for charging.
WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Compartment
Open When Charging.
2. Park the machine on a level surface and turn the
key off.
3. If charging wet (lead acid) batteries check the fluid
level before charging (See BATTERY
MAINTENANCE on page 25).
4. Prop up the recovery tank for ventilation when
charging (Figure 41).
FIG. 41
5. Connect the charger's AC power supply cord to a
properly grounded receptacle.
6. Connect the charger's DC cord into the machine's
battery receptacle at the rear of the machine
(Figure 42).
NOTE: The machine will not operate once the battery
charger is connected.
FIG. 42
20
Home Find... Go To..
ATTENTION: Do not disconnect the charger's DC
cord from the machine's receptacle when the
charger is operating. Arcing may result. If the
charger must be interrupted during charging,
disconnect the AC power supply cord first.
MACHINE MAINTENANCE
To keep the machine in good working condition, simply
follow the daily, monthly and quarterly maintenance
procedures.
WARNING: Electrical Hazard. Disconnect
Battery Cables Before Servicing Machine.
DAILY MAINTENANCE (After Every Use)
1. Drain and clean out the recovery tank (Figure 43).
FIG. 43
2. Remove the debris tray and empty (Figure 44)
FIG. 44
Tennant T3/T3+ (03- -08)