Tennant T3 Opérateur Manuel page 16

OPERATION
2. Open the recovery tank cover and rinse out the
tank. Use a rag to remove any excess dirt
(Figure 30).
FIG. 30
3. Clean the float shut-off screen and debris tray
located in the recovery tank (Figure 31).
DRAINING SOLUTION TANK
1. To drain any remaining water from the solution
tank, pull the solution tank level hose off the hose
fitting as shown (Figure 32).
FIG. 32
16
FIG. 31
Home Find... Go To..
2. To rinse out the solution tank, remove the
clean--out cap at the rear of the machine and
spray water, 60°C (140°F) maximum, directly into
the two fill--ports located under the recovery tank
(Figure 33).
FIG. 33
3. Remove and clean the solution tank filter
(Figure 34). Turn the filter counter--clockwise to
remove.
FIG. 34
4. After rinsing out the tank, securely replace the
solution tank filter, clean--out cap, fill--port covers
and hose.
Tennant T3/T3+ (01- -08)