Tennant T3 Opérateur Manuel page 10

OPERATION
INSTALLING BRUSH/PAD
NOTE: Refer to the BRUSH AND PAD
INFORMATION section in this manual or consult your
authorized distributor for brush and pad
recommendations.
1. Park the machine on a level surface and remove
the key.
2. Step down on the scrub head lift pedal to raise the
scrub head off the floor (Figure 6).
FIG. 6
3. Attach the pad to the pad driver before installing
the driver (Figure 7). Secure pad with centerlock.
FIG. 7
4. Turn the brush motor hub until the slot with the
spring clip is visible through the scrub head
window (Figure 8).
10
Spring Clip
FIG. 8
Home Find... Go To..
5. Align the pad driver mounting studs into the motor
hub slots and give the pad driver a quick turn to
engage spring clip (Figure 9). Single disk models:
If necessary, press down on the motor hub lock
pin to lock motor hub in place (Figure 10).
NOTE: For the dual disk model, the left and right pad
drivers engage the spring clip in opposite directions.
6. To remove the pad driver, grip the driver and give
it a quick turn away from the spring clip.
Single Disk Models: Press down on the motor hub
lock pin and turn the pad driver/brush clockwise
(Figure 10).
FIG. 10
Motor Hub
Spring Clip
Slot
Pad Driver/Brush
Mounting Stud
FIG. 9
Lock Pin
Tennant T3/T3+ (05- -10)