Tennant T3 Opérateur Manuel page 21

3. Remove and clean the float shut--off screen
located in the recovery tank (Figure 45).
FIG. 45
4. Drain the solution tank and rinse out the inside
with hot water, 60°C (140°F) maximum
temperature, as needed (Figure 46)
FIG. 46
5. Remove and clean the solution tank filter (Figure
47). Turn the filter counter--clockwise to remove.
FIG. 47
Tennant T3/T3+ (05- -10)
Home Find... Go To..
6. Rotate pad or replace when worn (Figure 48).
FIG. 48
7. Wipe the squeege blades clean. When machine is
not in use, raise the squeegee assembly off the
floor or hang it on the storage bracket (Figure 49).
FIG. 49
8. Check the condition of the squeegee blade wiping
edge (Figure 50). Rotate blade if worn.
(See SQUEEGEE BLADE REPLACEMENT)
FIG. 50
OPERATION
21