Vapormed Mighty Medic Mode D'emploi page 73

5. C O M M I S S I O N I N G A N D O P E R AT I O N O F T H E
5.4.1. Mains Operation
The MIGHT Y MEDIC Vaporizer can
also be operated with the power adapt-
er, even when the batteries are com-
pletely discharged. Proceed as de-
scribed in Chapter 5.4. "Charging the
Battery", page 71 and then switch
on the Vaporizer.
5.4.2. Automatic Switching Off
The automatic switching off is used
to save battery capacity so that the
MIGHT Y MEDIC Vaporizer can be
used as long as possible without
charging.
The device switches off automati-
cally two minutes after the last press
of a button or the last application. The
switching off of the MIGHT Y MEDIC
Vaporizer is indicated by a short vibra-
tion.
A short press of the ON/OFF
i
switch during operation can
reset the automatic switch-
ing-off to two minutes.
5.5. Heating Up
The MIGHT Y MEDIC Vaporizer pro-
vides two temperature levels that are
set in the factory: The basic tempera-
ture at 180°C (356°F) and the booster
temperature at 195°C (383°F).
M I G H T Y M E D I C VA P O R I Z E R
Switch on the device (heating up the
MIGHT Y MEDIC Vaporizer with in-
serted Dosing Capsule and Cooling
Unit mounted is recommended). To do
this, press the orange ON/OFF switch
for at least half a second. The Vapor-
izer responds with a short vibration.
The vibration does not take place if
there is a fault.
The display signals that heating is in
progress by showing the set and actual
temperatures. Set the desired temper-
ature (see Chapter 7. "The Use of Hemp
Flowers (Cannabis Flos)", page 78)
using the temperature buttons to the
left and right of the set temperature
display. Heating up the heat exchanger
can take up to two minutes, depend-
ing on the set temperature and battery
charge level. Once the set temperature
is reached, this is signaled by a short
double vibration.
If the basic temperature can no longer
provide adequate evaporation, the
booster temperature can be activated
by means of a double-click on the
orange-colored ON/OFF switch. Once
the booster temperature is reached,
this is signaled by a short double vibra-
tion and a blinking Set Temperature
display.
73