Publicité
Les langues disponibles
Les langues disponibles
4. Acquiring CEPH Images
4.3
42
Ask the patient not to block the ruler on the nasal
positioner by his / her fingers. It could deteriorate image
CAUTION
quality.
3. Click the Ready button after the patient has been properly positioned. No
X-Ray will be emitted at this point.
4. Proceed to section 4.3. Initiating X-Ray exposure.
Initiating X-Ray exposure
The X-Ray exposure method and process is the same for all CEPH modes.
The example and images below are taken from an X-Ray performed in CEPH
Lateral mode.
If a problem occurs during image acquisition, press the
red emergency stop button to immediately stop all moving
parts and cut off all power to the equipment's electrical
components. You may then safely release the patient from
the equipment.
To reset this button, turn it clockwise until it pops up.
WARNING
Do not operate the PC during exposure. Failure to comply
with this instruction may cause the system to malfunction.
WARNING
PaX-i (PCH-2500) User Manual
Publicité
