Connecting elements
M6x25
M4x10
M6x10
Ø4xØ12
3x
2x
6x
Assembly procedure
CAUTION!
For your own safety the bolt heads
should
always
otherwise there is a risk of injury.
In
order
to
prevent
material tension only tighten all of the
screw connections after completing
assembly.
1. Place an ash collecting tray holder
(J) and a leg support (H) over each
of the upper ends of the legs (I + O).
Attach the stands (I + O) to the fire
bowl (G) in the order illustrated. Use
the M6x25 bolts and the Ø6xØ20
washers
(screws have already been pre-
.
assembled)
2. Insert the front tab of the wire shelf (L)
into the lower hole on the standing
leg (O).
Insert the ends of the wire shelf (L)
through the lower holes in the stand
(I). Install the wheels (K) to the end of
the wire shelf (L) using the Ø6xØ12
plastic washers and M6 lock nuts.
3. Screw two of the handles (A) onto the
firebowl (G) using the M6x10 bolts,
Ø6xØ12 washers and M6 nuts. Use
the M6x10 bolts, Ø6xØ12 washers
and M6 nuts to fasten the hood
bracket (D) to the handle (A) and the
heat shield (R) from inside the hood
(C).
Ø6xØ12
Ø6xØ20
M4
2x
6x
3x
2x
point
outwards,
undesired
M6
M6
Ø6xØ12
6x
2x
2x
4. Attach the straight ventilation disc (Q)
to the fire bowl (G) using M4x10
screws, Ø4xØ12 washers and M4
nuts from the outside. Repeat this step
with the curved ventilation disc (B) on
the hood (C).
5. Clamp the ash collecting tray (N)
into the ash collecting tray holder (J)
between the stand (I + O).
6. Now securely tighten all screw
connections.
7. Insert the charcoal grid (F) and the
cooking grill (E) into the fire bowl (G).
If required, place the coal divider (P)
on the charcoal grill (F).
Also note the instructions on the following
pages.
WARNING!
The barbecue must be positioned on a
stable and secure surface when it is in
use, otherwise it may tip over.
13