Maintenance; General; Daily Cleaning - Hatco FS2HAC Série Manuel D'installation Et D'utilisation

OPERATION
• When three sheet pans are being used, position the pans
to avoid having to pull out the pans for serving. Re-position
pans as they are emptied.

MAINTENANCE

General

Hatco Flav-R-Savor Air Curtain Cabinets are designed for
®
maximum durability and performance, with minimum
maintenance.
WARNING
ELECTRIC SHOCK HAzARD:
• Turn OFF power switch, unplug power cord, and allow
unit to cool before performing any cleaning,
adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on the unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.

Daily Cleaning

To preserve the bright finish of the unit, it is recommended that
the exterior and interior surfaces be cleaned daily.
NOTICE
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring
its appearance and making it susceptible to soil
accumulation.
Shelves #1, #2, and #3
Shelves #1, #2, and #4
FS2HAC-4PT with Three Pans
1. move the Power I/O (on/off) switch to the "O" (off) position
and allow the unit to cool.
NOTE: A cooling fan inside the unit will run for a short time after
the unit is turned off.
2. Remove and wash all food sheet pans.
3. Wipe all crumbs on the floor of the cabinet into the crumb
trays on each end of the unit.
4. Remove, empty, and wash the crumb tray on each end of
the unit. To remove the crumb trays:
• Lift the tray up and over the pegs on each side wall inside
the unit.
• Pull the tray straight out of the unit.
Removing the Crumb Tray
5. Wipe the exterior and interior of the unit with a clean,
sanitized cloth.
• Hard to reach areas may be cleaned using a small brush
and mild soap.
• Stubborn stains may be removed with a good stainless
steel cleaner or a non-abrasive cleaner.
10
English
#3
#2
#1
Shelves #1, #3, and #4
#4
#2
#1
Form No. FS2HACm-0815
#4
#3
#1