Optika Italy B-1000 Serie Mode D'emploi page 18

8. Screw each objective into the thread of the nosepiece,
clockwise with increasing magnification. (Fig. 9)
9. Mount the stage: lower the support using the coarse focus
knob, then place the stage and firmly tighten the lock screw
⑩. (Fig. 10)
Only for transmitted and reflected light version:
10. Insert the condenser under the stage: position until it is well
inserted into its holder (under the condenser there is a pin
that must fully enter the holder guide). (Fig. 11)
11. Lock the condenser fixing knob ⑪.
12. Insert the power supply jack in the socket placed in the rear
side of the of the microscope. (Fig. 12)
⑩
⑪
Page 18
F ig. 9 F ig. 9
F ig. 10 F ig. 10
F ig. 11 F ig. 11
F ig. 12 F ig. 12