Optika Italy B-1000 Serie Mode D'emploi page 17

4. Connect the illuminator cable ⑥ to the connector ⑦ placed
on the back side of the power supply. (Fig. 5)
5. Connect the power supply to the connector ⑧ placed on the
back side of the power supply. (Fig. 6)
6. Insert the optical head above the illuminator and tighten the
locking screw ⑨ with the provided Allen wrench. (Fig. 7)
• Hold the head with one hand during the locking in order
to avoid that the head falls.
7. Insert both eyepieces into the tubes of the optical head. (Fig.
8)
Page 17
⑦
⑥
⑧
⑨
F ig. 5 F ig. 5
F ig. 6 F ig. 6
F ig. 7 F ig. 7
F ig. 8 F ig. 8