Publicité
Les langues disponibles
Les langues disponibles
Front and Rear Gear Case
Inspect the front and rear gear case for any leaks before operating
the vehicle, if found any leaks, stop operating the vehicle and
contact with your dealer for inspection and service.
Change the Front and Rear Gear Case Oil
1. Place the vehicle on level ground and in parking position.
2. Place an oil pan under the gear case to collect the used oil.
3. Remove the magnetic drain bolt and washer at the bottom of
gear case.
4. Clean any debris or contaminants from the magnetic drain bolt.
Replace the washer with new one if damaged.
5. Wait for several minutes until the gear case is completely
drained.
6. Install magnetic drain bolt and washer.
Drain Bolt Torque : 18�4 ft-lb� ( 2 5 N·m )
7. Remove filling bolt and washer ( 3 ) .
8. Add the recommended type of oil ( SAE 80W-90 GL-5 ) by
specified volume using the funnel, funnel extension tube and
tube adapter that are supplied with the vehicle.
Front gear case oil volume: 8�4 oz� (250 mL )
Maintenance
141
Drain hole,front
1
2
gear case
1
2
Drain hole,rear
gear case
Publicité
