Setting The Barking Detection Sensitivity - Num'axes Canicalm Sonic Guide D'utilisation

Number of beep sounds heard when
switching modes

Setting the barking detection sensitivity

Setting the barking detection sensitivity ensures detection of any barking but helps avoid
unnecessary detection. The detection, must therefore be sufficiently sensitive but not overly
sensitive. In factory, barking detection sensitivity is set on the maximum position (maximum
sensitivity).
To adapt the detection sensitivity to the barking strength of your dog, you should proceed as
follows:
- Remove the 2 screws from the battery cover with a screwdriver.
- Remove the battery cover.
- Carefully turn the setting screw according to the sensitivity you wish (See. Diagram 5)
Caution: the adjustment system has a stop for the minimum sensitivity and a stop for the
maximum sensitivity. Turn delicately and without forcing with the supplied screwdriver.
- Put the battery cover back in place taking care to insert first the little pin at the bottom of the
battery cover (See diagram 3).
- Retighten moderately the 2 screws.
MINIMUM sensitivity
Diagram 5
1
2
3
MEDIUM sensitivity
Mode
1 ultrasounds only
2 vibrations only
3 ultrasounds + vibrations
MAXIMUM sensitivity
Gb - 14
Operation
Screwdriver