Setting The Barking Detection Sensitivity; Checking/Replacing Battery - Num'axes IKI SONIC Guide D'utilisation

The chart below indicates how your collar operates according to the modes you have selected:
Number of sound beeps heard when
switching modes
1
2
3

Setting the barking detection sensitivity

Setting the barking detection sensitivity is a very important preliminary operation. In fact, this setting
determines the correct operation of the product.
It ensures detection of any barking but helps avoids unnecessary detection.
The detection, must therefore be sufficiently sensitive but not overly sensitive. In factory, barking
detection sensitivity is set on the maximum position (maximum sensitivity).
To adapt the detection sensitivity to the barking strength of your dog, you should proceed as follows:
- Remove the 2 screws from the battery cover with a screwdriver.
- Remove the battery cover.
- Carefully turn the setting screw according to the sensitivity you wish (See. Diagram 5)
Caution: the adjustment system has a stop for the minimum sensitivity and a stop for the
maximum sensitivity. Turn delicately and without forcing with the supplied screwdriver.
- Replace the battery cover taking care to insert first the little pin at the bottom of the battery cover
(See diagram 3).
- Retighten moderately the 2 screws.
Diagram 5
Checking/ Replacing battery
When the battery is too weak for the operation of the product, sound beeps indicate it in 2 cases:
- When switching On the collar: a series of close sound beeps + number of beeps meant to indicate the
operating mode are emitted
MINIMUM sensitivity
MEDIUM sensitivity
Mode
1 ultrasounds only
2 vibrations only
3 ultrasounds + vibrations
MAXIMUM sensitivity
Gb - 14
Operation
small plastic screwdriver