Setting The Barking Detection Sensitivity - Num'axes iki pulse Guide D'utilisation

Keep the magnetic key in contact with the orange mark to run through modes.
Remove the magnetic key when you have reached the mode you wish.
The collar will memorize your selected mode.
Next time you will switch on the collar, your collar will be turned on to the last mode you previously selected.
The chart below indicates how your collar operates according to the mode you have selected :
Number of beep
sounds heard when
switching modes
1
2
3
4
4
5
6
7
4

Setting the barking detection sensitivity

Your dog's barking is detected by the contact points which sense the vibrations of his vocal cords.
Setting the barking detection sensitivity is a very important preliminary operation. In fact, this setting determines the correct
operation of the product.
It ensures detection of any barking but helps avoid unnecessary detection. The detection must therefore be sufficiently sensitive
but not overly sensitive.
In the factory, detection sensitivity is set on the medium position (medium sensitivity).
To adapt the detection sensitivity to the barking strength of your dog, you should proceed as follows:
- Remove the protection tab located at the back of the collar (See. Diagram 3).
- Carefully turn the setting screw according to the sensitivity you wish using the supplied screwdriver (See. Diagram 3).
CAUTION: the adjustment system has a stop for the minimum sensitivity and a stop for the maximum sensitivity. Turn
delicately and without forcing with the supplied screwdriver.
- Put the protection tab back in place making sure it is positioned correctly. then press strongly to ensure that it is
engaged.
Mode
1 Beep sounds only
2
3
Sensitive dog
4
4
5
6
Difficult dog
7
4
Operation
Beep sound + short stimulation
Beep sound + long stimulation
Beep sound + progressive stimulation
(short then long)
Beep sound + short stimulation
Beep sound + long stimulation
Beep sound + progressive stimulation
(short then long)
Gb - 15