Setting The Barking Detection Sensitivity - Num'axes iki voice Guide D'utilisation

­ To record your message 1:
- Select the mode 3: release the button when the mode 3 is reached.
- To record your vocal message 1, press again on the button and maintain the pressure during the
recording of your message (speak near your collar). At the end of the recording, loosen the
button.
­ To listen your message 1:
- Select the mode 1: release the button when the mode 1 is reached.
- Your collar plays message 1.
For your message 2, proceed in the same way by selecting mode 4 to record it and mode 2 to listen to it.
The chart below presents the different modes concerning the recording and listening of vocal
messages:
Number of sound beeps heard
when switching modes

Setting the barking detection sensitivity

Setting the barking detection sensitivity is a very important preliminary operation. In fact, this setting
determines the correct operation of the product.
It ensures detection of any barking but helps avoids unnecessary detection.
The detection must therefore be sufficiently sensitive but not overly sensitive.
In the factory, detection sensitivity is set on the medium position (medium sensitivity).
To adapt the detection sensitivity to the barking strength of your dog, you should proceed as follows:
- Remove the 2 screws from the battery cover with the supplied screwdriver.
- Remove the battery cover.
- Carefully turn the setting screw according to the sensitivity you wish (See. Diagram 5)
- Caution: the adjustment system has a stop for the minimum sensitivity and a stop for the
maximum sensitivity. Turn delicately and without forcing with the supplied screwdriver.
- Replace the battery cover taking care to insert first the little pin at the bottom of the battery
cover (See diagram 3).
- Retighten moderately the 2 screws.
1
2
3
4
Mode
1 Listening of vocal message 1
2 Listening of vocal message 2
3 Recording of vocal message 1
4 Recording of vocal message 2
Gb - 17
Operation