Chicco Oasys 1 Evo Isofix Notice D'utilisation page 22

must be fitted so as to allow that the harnesses
come out from the backrest at the height of the
child' s shoulders (diag. 32). To adjust the height,
press the adjustment button (M), located at the
rear of the backrest (diag. 33) and, at the same
time, slide the headrest until the desired position
is reached (diag. 34); now release the button and
ease the headrest until a click is heard, indicating
that it is locked correctly into position.
To tighten the restraint harnesses of the child
car seat, pull the adjustment strap of the
restraint harnesses (E) (Diag. 35), until they are
correctly fitted to the child's body.
After tightening the restraint harnesses,
hold the shoulder straps and pull them in a
downward direction to adjust the harnesses
to the child's body.
WARNING! Do not over-tighten the harnesses
around the child: if you can insert one finger
between the harness and your child' s shoulders,
it means that they are tightened correctly
WARNING! Check that the harness straps are
not twisted.
ADJUSTING THE INCLINATION OF THE
CHILD CAR SEAT
The child car seat can be reclined to 5
positions.
To adjust the inclination of the child car
seat, pull the lever located under the seat (L)
towards you (Diag. 36).
WARNING! After adjusting the child car seat to
the desired position, first release the lever, and
then continue to move the seat until a click
is heard, indicating that the lever is locked
correctly.
WARNING! During the adjustment operations,
ensure that no mobile parts come into contact
with the child or other children in the car.
MAINTENANCE
The cleaning and maintenance operations
must only be carried out by an adult.
How to clean the fabric cover
The child car seat's fabric cover can be
removed and cleaned by hand or in a washing
machine at 30°C. Please refer to the care label
for instructions on cleaning the seat fabric.
Machine washable at 30°C.
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
Never use abrasive detergents or solvents. Do
not spin dry the fabric cover, let it dry without
wringing it.
The fabric cover must only be replaced with
another cover approved by the manufacturer,
since it is an integral part of the child car seat
and, therefore, one of its safety elements.
WARNING! To ensure the safety of the child car
seat, never use it without its fabric cover.
Now remove the cover following the
instructions below:
1. Press the restrain harnesses adjustment
button and, at the same time, hold the two
harnesses of the child car seat, located under
the shoulder straps, and pull in your direction
to loosen them (diag. 37);
2. unfasten the restraint harness, pressing the
red button on the buckle (diag. 38);
3. remove the cover starting from the reclining
button at the bottom (Diag. 39);
4. release the Press Studs located in the centre
of the backrest (Diag. 40), then remove the
seat fabric from the child car seat;
5. repeat this procedure for the other strap
(Diag. 41);
6). remove the seat fabric cover from the side
(Diag. 42 and the top (Diag. 43);
7. remove the headrest cover by opening the
buttons on the back (Diag. 44).
To replace the fabric cover, perform the above
operation in the reverse order from 7 to 1.
How to clean the plastic or metal parts
Clean the plastic and coated metal parts
with a damp cloth only. Never use abrasive
detergents or solvents.
The movable parts of the child car seat must
22