Chicco Oasys 1 Evo Isofix Notice D'utilisation page 20

E. Restraint harness adjustment strap
F. Harness open / close buckle
G. Seat Fabric
H. Padded crotch strap
I. Child seat base
J. Seat
K. Handle to release the ISOFIX system
L. Reclining adjuster lever
Diag. 2 (Back)
M. Headrest adjustment button
N. Homologation labels
O. Isofix connectors
P. Top Tether
Q. Instruction manual holder
Diag. 3 (Profile)
R. Installation instructions labels
S. ISOFIX system
Diag. 4 (ISOFIX System Detail)
T. Connectors
U. Protective caps
V. Release buttons
W. Locking indicators
Diag. 5 (TOP TETHER Detail)
AA. Belt
BB. Adjuster
CC. Tension indication
DD. Hook
RESTRICTIONS AND REQUISITES RE-
GARDING THE USE OF THE PRODUCT AND
CAR SEAT
WARNING! Read these use restrictions and
requisites carefully to ensure the product is
used safely.
• The child car seat is suitable for children from
9 up to 18 Kg of weight.
• The child car seat must be fitted with the
ISOFIX system in the positions indicated in
the instructions for use of the vehicle.
WARNING! In case of use in vehicles equipped
with rear seat belts with integrated airbags
(inflatable belts), the interaction of the
inflatable portion of the vehicle's belt with this
child restraint can result in serious injury or
death! Do not install this child restraint using
an inflatable seat belt. Install using ISOFIX
instead, or move the car seat to a position
with a suitable seat belt type. When installing
with ISOFIX, the unused seat belt should not
be buckled behind the Child Restraint System
as this will engage the inflatable portion of
the belt.
WARNING! If the vehicle manual allows ISOFIX
installation of the child car seat on the front seat
of the car, in order to ensure maximum safety, it
is recommended to push the seat back as much
as possible, bearing in mind the comfort of the
passenger sitting in the seat directly behind it
and adjusting the backrest to the most vertical
position. It is not recommended to fit the child
car seat into a front seat equipped with airbag.
If you wish to fit the child car seat in any seat
protected by airbag, always refer to the vehicle
instructions manual.
FITTING THE CHILD CAR SEAT INTO THE
CAR WITH THE ISOFIX SYSTEM
Preparing for installation
1. Pull the unlocking handle (K) of the ISOFIX
system externally (diag. 6).
2. While keeping the handle pulled, pull out
the ISOFIX system COMPLETELY from the
rear of the backrest (diag. 7). Ensure that the
system has been pulled out as far as possible.
3. Push the two red buttons (Y) of the ISOFIX
connectors inwards (diag. 8) and remove the
two protective caps. 9).
4. Place the two caps into the appropriate
compartments, located between the base
and the seat, once the latter has been reclined
completely (diag. 10).
WARNING! Store the caps carefully, since they are
indispensable for reinserting the ISOFIX system
in to the base when the system is not in use.
How to fit the child car seat
5. Place the child car seat onto the vehicle seat
following the recommendations provided
in the instruction manual of your vehicle.
WARNING! Check that there are no loose
objects between the child car seat and the
car seat or between the child car seat and the
door of the car.
20