Scio Setup; Etco2* Monitoring - Siemens Scio Manuel De Référence

5. Press
Cal. in Progress.
6. When the 100%-O
plays the message
Wait for the value in the parameter box to stabilize and then
remove the O
7. Click on
When the calibration is complete, the monitor displays
Oxygen Cal. Accepted and t
to the menu field Last O2 Cal. If the calibration fails, the monitor
displays an error message (see page 20 for status messages).
S Setup
CIO
Scio parameters are displayed in the etCO
thetic Agent and parameter boxes. Each has its own setup menu,
described in the following pages.
NOTES:
!
!
etCO * Monitoring
2
The etCO
ments calculated by the Scio module. The etCO
displays the current values for:
Inspired CO
ing the inspiration phase.
End-tidal CO
at the end of expiration.
Respiration Rate (RRc*) — The patient's respiration rate,
derived from the etCO
over the two most recent breaths.
Page 8
. The monitor displays
Continue
calibration is complete, the monitor dis-
2
Remove 100% O2, then Press Continue.
source.
2
.
Continue
Some Scio parameter labels are marked by an asterisk (*) to
distinguish them from parameters monitored by the etCO
or module.
You can display the O
combined parameter box (see page 15).
* waveform displays the instantaneous CO
2
( ) — The level of CO
iCO *
2 2
( etCO
2 2
2
Scio MODULE D011100
M
ULTI
he current date and time appear next
*, O
2
/N O and agent parameters in a single
2 2
* ) — The level of CO
* signal by calculating an average rate
G Oxygen
AS
M G
ULTI AS
/N O and Anes-
2 2
pod
2
measure-
2
* parameter box
2
in the airway dur-
2
in the airway
2
SC 7/8/9XL VF2.x