Siemens Scio Manuel De Référence page 11

The O cell in the Scio does not require routine calibration, how-
2
ever, the user may choose to perform a 1-point or 2-point calibra-
tion in the event that the measured values are not as expected. A
1-point calibration is performed against room air (typically 21%
1% O ) and a 2-point calibration is performed against 100% O
2
as well as room air.
A yearly check of the Scio calibration components should be per-
formed by authorized technical personnel.
1 Point Calibration
1. Access the O
G
menu (see page 15).
AS
2. Click on
During calibration, the monitor displays the message
Oxygen Cal. in Progress.
monitor displays
rent date and time appear next to the menu field Last O2 Cal. If
the calibration fails, the monitor displays an error message (see
page 20 for status messages).
2 Point Cal.
1. Make sure a medical-grade O
2. Access the O
G
menu (see page 15).
AS
3. Click on
sage Supply 100% O2, then Press Continue.
4. Connect the O
supply 100% oxygen. Wait until the waveform levels off at a
maximum display height and the numerical data in the O
parameter box is stable. This may take several minutes on
older O
WA RN IN G : The O
box must be stable before calibration continues, other-
wise the monitor cannot obtain a reliable calibration
constant, which results in inaccurate measurements.
SC 7/8/9XL VF2.x
menu (see page 11) or the combined M
2
1 Point Cal.
When the calibration is complete, the
M G Oxygen Cal. Accepted and t
ULTI AS
menu (see page 11) or the combined M
2
2 Point Cal. A popup screen appears with the mes-
source to the water trap on the module and
2
cells.
2
value in the M
2
Scio MODULE D011100
Scio Module
M
source is available.
2
G parameter
ULTI AS
±
2
-
ULTI
G
ULTI AS
he cur-
-
ULTI
2
Page 7