Charging Modes - BorMann PRO BBC4020 Mode D'emploi

EN EN
LCD ICONS:
Battery repair function
Connecting to the battery
1. Identify polarity of battery posts. The positive battery terminal is typically marked by these letters or symbols (POS,P,+). The negative battery terminal is
typically marked by these letters or symbols (NEG,N,-).
2. Do not make any connections to the carburetor, fuel lines, or thin metal parts.
3. Identify if you have a negative or positive grounded vehicle. This can be done by identifying which battery post (NEG or POS) is connected to the chassis.
4. For a negative grounded vehicle (most common): connect the RED POSITIVE clamp first to the positive battery terminal, then connect the BLACK NEGATIVE
clamp to the negative battery terminal or vehicle chassis.
5. For a positive grounded vehicle (very uncommon): connect the BLACK NEGATIVE clamp first to the negative battery terminal, then connect the RED POSITIVE
clamp to the positive battery terminal or vehicle chassis.
6. When disconnecting, disconnect in the reverse sequence, removing the negative first (or positive first for positive ground systems).
7. A marine (boat) battery must be removed and charged on shore. To charge it on board requires equipment specially designed for marine use.

Charging modes

Ιmportant Note:
The BBC4020 charger has 12 modes: Standby, 12V STD, 12V COLD/AGM, 12V LITHIUM (LIFEPO4), 12V CAL, 24V STD, 24V COLD/AGM, 24V CAL , 13,6V SUPPLY,
REPAIR, 12V ALTERNATOR CHECK, BATTERY HEALTH CHECK. Do not operate the charger until you confirm the appropriate charge mode for your battery. CAU-
TION: If you choose 24V Mode(s) for 12V battery, the 12V battery will be damaged!
Mode Battery Size (Ah)
Standby
12 V STD
12 V COLD/AGM
12 V CAL
24 V STD
24 V COLD/AGM
24 V CAL
12 V LITHIUM
REPAIR
13,6 V SUPPLY
12V ALTERNATOR CHECK
BATTERY HEALTH
CHECK
The following modes are advanced charging modes that require your full attention before selecting.
3
Battery CCA detection display / battery voltage display / battery function display
Generator detection display
Battery health
percentage display
Battery internal
resistance display
CCA test of battery
Battery voltage to
start charging
Ordinary lead-acid
battery
Low temperature charging
mode and AGM battery type
- Not charging or providing any power. The user can check the Remaining Battery Capacity (State of Charge)
14-230 Charging 12V STD batteries
14-230 Charging 12 V batteries below 10
14-230 Charging 12 V CAL batteries
14-115 Charging 24 V STD batteries
14-115 Charging 24 V batteries below 10
14-115 Charging 24 V CAL batteries
14-230 Charging 12 V lithium-ion (LiFePO4) batteries only
14-230 An advanced battery recovery mode for repairing old, idle, stratified or sulfated batteries
- Converting to a DC power supply for powering 12 V DC device or as a memory retainer when replacing a battery.
- Check vehicle's alternator output
- Check battery health (LEAD-ACID only), including SOC, SOH, CCA and internal resistance
WWW.NIKOLAOUTOOLS.GR
Power mode (13,5 V 5 A)
Battery charging
dynamic display
Battery remaining
capacity display
warning and battery
(LiFePO4 12V lithium
battery 4 Cell LiFePO4)
Battery capacity to
Total time required for
start charging
charger charging
Total capacity of fully
charged battery
Explanation
C (50 F) or 12V AGM battery
o o
C (50 F) or 24 V AGM battery (Green LED)
o o
Short circuit