Publicité
Les langues disponibles
Les langues disponibles
NERONE
EN |
| User and Maintenance Manual
6.7 FAN CASING DISMANTLING AND FAN REMOVAL/
REPLACEMENT
Switch off the oven and disconnect it from the electrical network. Wait for it to cool and the fan to stop.
1)
Lift the rack by a few centimetres from the side where lamp to be replaced is located, freeing it from the
2 latches that secure it at the bottom of the baking chamber (Picture 1 paragraph 6.5).
2)
Tilt it by approximately 30° towards the centre of the oven and then remove it from the 2 pins that
secure it on the top of the cooking chamber (Picture 2 paragraph 6.5).
3)
Repeat the operations with the opposite rack and then remove it.
4)
Unscrew by hand the 4 pins that secure the fan casing to the bottom and top of the cooking chamber.
5)
Gently remove the fan casing.
5B)
If the oven is equipped with "steam" function, loosen the 3 screws that secure the water inlet pipe to
the bottom of the cooking chamber, turning it downwards and then release the fan.
6)
Unscrew the M5 nut that secures the fan to the motor using a 8 mm hex wrench and remove the fan.
To refit the oven components, carry out in reverse the procedure described above.
6.8 REMOVING/REPLACING THE FAN MOTOR
Switch-off the oven and disconnect it from the electrical network before replacing the motorfan.
1)
Lift the rack by a few centimetres from the side where lamp to be replaced is located, freeing it from the
2 latches that secure it at the bottom of the baking chamber (Picture 1 paragraph 6.5).
2)
Tilt it by approximately 30° towards the centre of the oven and then remove it from the 2 pins that
secure it on the top of the cooking chamber (Picture 2 paragraph 6.5).
3)
Repeat the operations with the opposite rack and then remove it.
4)
Unscrew by hand the 4 pins that secure the fan casing to the bottom and top of the cooking chamber.
5)
Gently remove the fan casing.
5B)
If the oven is equipped with "steam" function, loosen the 3 screws that secure the water inlet pipe to
the bottom of the cooking chamber, turning it downwards and then release the fan.
6)
Unscrew the nut that secures the fan to the motor and remove the fan.
7)
Remove the back panel of the oven.
8A)
Disconnect the motor from the electrical system.
9B)
Loosen the 4 M6 screws with a 10 mm socket wrench.
Carefully remove the motor.
10)
A
48
4
B
8
B
B
5
9
B
To refit the oven components,
carry out in reverse the procedure
described above.
B
6
Publicité
