NERONE MID Serie Notice D'utilisation page 39

1.6 FEET POSITIONING AND ADJUSTMENT
2 ELECTRICAL CONNECTION AND EARTHING
2.1 ELECTRICAL POWER SUPPLY
The installation and the electrical connections must be carried out in conformity with the electri-
cal rules in force. These operations must be carried out by qualified staff.
The Company declines any responsibilities originated from the no observance of the
above rules in force.
See the OVEN wiring diagram at "APPENDICE - 3" Pag. 176
BEFORE PLUGGING IN:
It is necessary to proceed with its complete and careful cleaning using warm water with no aggressive
detergents and drying with a soft cloth all the humid parts.
In order to carry out a correct plug in you must proceed as follow:
• Arrange a differential circuit breaker and verify that the frequency / tension of the line correspond
to those written on the identification label of the Oven
Check the supply voltage at the socket, is the nominal ±10% at power up.
•
• Install an upstream switch with a contact opening distance that allows complete disconnection under
category III overvoltage conditions according to the installation rules.
It is necessary thatthe connection cable section is commensurate to the power consumption of the unit.
•
The law requires that the unit is earthed; therefore it is necessary to connect it to an efficient earth connection.
•
The plug of the oven must always be connected to a fixed socket.
It is forbidden to connect the plug of the oven to an extension cord and/or or to a reducer.
MINIMUM SECTIONS OF THE POWER SUPPLY CABLE:
4/5/6 TRAYS:
7/10 TRAYS:
POWER SUPPLY CABLE TYPE:
NEOPRENE CABLE
ATTENTION
If the supply cable is damaged, it must be replaced by the manufacturer or by the latter's technical
assistance service or anyhow by a person with similar qualification, such as to prevent any risk.
2.2 CONNECTING THE EQUIPOTENTIAL TERMINAL
Connect the oven to earth and insert it in the equipotential circuit.
The terminal used for this purpose is located at the rear of the oven, and is marked by the
international symbol shown in the figure.
Place the oven perfectly upright, adjusting if necessary the screw feet of the legs of the
appliance to adjust the level.
Check evenness with a spirit level.
The oven must be placed on a perfectly flat surface in order to work properly and to allow
correct water drainage. Noisy motor vibrations also are avoided.
Ø 2,5 mm
Ø 4,0 mm
H07RN-F 5G4
NERONE
| User and Maintenance Manual | EN
39