Operation Guidance - GYS NOMAD POWER PRO 700 Mode D'emploi

Translation of the original instructions

OPERATION GUIDANCE

Press the switch 2
level of NOMAD POWER
!
RECHARGE THE NOMAD POWER before first use and after each use.
CHARGING INSTRUCTION
It is best to charge the Nomad Power at a temperature > 10°C. If the temperature is below 0°C, do not
charge the Nomad Power. Place the Nomad Power in a temperate room for 1 hour before charging.
!
Recharge the NOMAD POWER to 100% every 6 months after a long period of inactivity to keep its perfor-
mance intact.
1. Plug the home adaptor into the universal socket
2. Connect the Type-C connector to the NOMAD POWER host
3.The indicator
1
paused or completed
USING AS JUMP START 12 V
Do not start a Lithium LiFePO4 battery with this booster as it is equipped with a Lithium NMC battery
whose voltage is not compatible.
1. Connect the jump start socket into the host
2. Connect red clamp to the positive (+) battery terminal, black clamp to the negative (-)
battery terminal.
3. Operate following the instruction of the cable indicator :
10
NOMAD POWER PRO 700
Indicator
to check the storage
will flash one by one during the period of charging. All indicators light off when the charging is
Storage
level
100%
75%
50%
25%
0%
7
8
, and make sure the Cable Indicator is off.
EN