GYS NOMAD POWER PRO 700 Mode D'emploi page 11

Translation of the original instructions
GREEN LIGHT On :
Telling the connection is correct and
the circuit is working, you can turn
on the engine to jump-start directly.
GREEN LIGHT blinking with
buzzing :
Saying the vehicle battery is low,
press the «BOOST» button, wait
GREEN LIGHT becomes solid, then
turn on the engine within 30s.
4.Start the vehicle.
Only jump start when 3 to 4 indicator lights are illuminated.
Do NOT Jump Start more than 3 times in a row. It could damage the unit by overheating.
Give two minutes between attempts. The jumping cable can become overheated and detach
as a safety measure.
The jumping cable may overheat. In this case a protection system cuts the tension at the
clamps.
5.When the vehicle is started, remove the jumper cable from the vehicle battery. Leave the vehicle's engine running.
Remove the product from the vehicle battery within 30 seconds of Jump Starting. If not, it
could lead to damage.
USING AS POWER SUPPLY
Charging Cell Phone or Tablet Instruction
1. Plug the switch cable to Quick Charge output port
2. Select appropriate connector and connect it to your mobile phones or tablet.
3. Touch the switch button
phone/tablet etc.
For power supply to vehicle products or electronics
1. Plug the optional switch cable to 15 V /10 A output port
2. Connect the optional switch cable and vehicle product or electronics
3. Press the switch button
NOMAD POWER PRO 700
, it can recognise eletronic products's suitable parameters, start to charge for mobile
2
to power supply
2
5
3
RED LIGHT On with buzzing :
Telling the connection is wrong,
and buzzing to alarm to correct the
clamps as step 2 mentioned above,
wait until the GREEN LIGHT is on to
turn on the engine.
No lights on, no buzzing :
Saying the vehicle's battery may-
be damaged, after confirmed the
clamps connection is correct, press
the «BOOST» button, wait GREEN
LIGHT is on, and then turn the en-
gine within 30s.
EN
11