Operation Guidance - GYS NOMAD POWER PRO 700 Mode D'emploi

Translation of the original instructions

OPERATION GUIDANCE

Press the switch 2
level of NOMAD POWER
CHARGING INSTRUCTION
1. Plug the home adaptor into the universal socket
2. Connect the Type-C connector to the NOMAD POWER host
3.The indicator 1
paused or completed
USING AS JUMP START 12 V
1. Connect the jump start socket into the host
2. Connect red clamp to the positive (+) battery terminal, black clamp to the negative (-)
battery terminal.
3. Operate following the instruction of the cable indicator :
10
All manuals and user guides at all-guides.com
NOMAD POWER PRO 700
Indicator
to check the storage
will flash one by one during the period of charging. All indicators light off when the charging is
GREEN LIGHT On :
Telling the connection is correct and
the circuit is working, you can turn
on the engine to jump-start directly.
GREEN LIGHT blinking with
buzzing :
Saying the vehicle battery is low,
press the «BOOST» button, wait
GREEN LIGHT becomes solid, then
turn on the engine within 30s.
Storage
level
100%
75%
50%
25%
0%
7
8
, and make sure the Cable Indicator is off.
RED LIGHT On with buzzing :
Telling the connection is wrong,
and buzzing to alarm to correct the
clamps as step 2 mentioned above,
wait until the GREEN LIGHT is on to
turn on the engine.
No lights on, no buzzing :
Saying the vehicle's battery may-
be damaged, after confirmed the
clamps connection is correct, press
the «BOOST» button, wait GREEN
LIGHT is on, and then turn the en-
gine within 30s.
EN