Parker AC10 Serie Manuel Du Produit page 9

1-7
• Set the I/O control mode
The channel for inverter to receive control commands (including start, stop and jogging, etc) contains 5 modes: 0. Keypad control; 1. Terminal control; 2.
Keypad + terminal control 3. Modbus control; 4. Keypad + terminal +Modbus. The modes of control command can be selected through the function codes
F200 and F201.
For terminal control please check the selector switiched for the analogue inputs.
Coding Switch 1
OFF
OFF
ON
Also check the NPN, PNP selector switches for the digital inputs.
• Test run the inverter
Test run the inverter from the keypad or the terminal control, checking all conditions are safe.
• For advanced functions see the full manual.
F200 Source of start command
F201 Source of stop command
F203=2, channel AI2 is selected
SW1 coding switch
Coding Switch 2 Mode of Speed Control
OFF 0~5V voltage
ON 0~10V voltage
ON 0～20mA current
www.comoso.com
0: Keypad command;
1: Terminal command;
2: Keypad＋Terminal;
3:MODBUS;
4: Keypad＋Terminal＋MODBUS
0: Keypad command;
1: Terminal command;
2: Keypad＋Terminal;
3:MODBUS;
4: Keypad＋Terminal＋MODBUS
F203=1, channel AI1 is selected
0~10V voltage
English