Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
REPAIR PARTS LIST
Using "Commercial" or other manufacturer's parts to repair the CM
Series 622A Hoists may cause load loss.
Use only CM supplied replacement parts. Parts may look alike but
CM parts are made of specific materials or processed to achieve
specific properties.
ORDERING INSTRUCTIONS
The following information must accompany all correspondence
orders for replacement parts:
1. Hoist Model Number from identification plate.
2. Serial number of the hoist stamped below identification plate.
3. Length of lift.
4. Part number of part from parts list.
5. Number of parts required.
6. Part name from parts list.
NOTE: When ordering replacement parts, it is recommended
that consideration be given to the need for also ordering such
items as gaskets, fasteners, insulators, etc. These items may
be damaged or lost during disassembly or just unfit for future
use because of deterioration from age or service.
RECOMMENDED SPARE PARTS
To insure continued operation, it is recommended that two friction
washers
for each Series 622A Hand Hoist in service be kept on hand at all
times to replace friction washers that are worn, contaminated or
glazed. See below
for ordering information.
Brake Set
Friction Washer
Latch Kit
Upper & Lower Hook Assembly
Alterations or modifications of equipment and use of any parts other
than CM
622A Series lever hoist repair parts can lead to dangerous
®
operation and injury.
Do not alter or modify equipment. Do use only CM
provided replacement parts.
CMK_12346 622 Series Hoist Manual Rev AB_v1.indd 8
TO AVOID INJURY:
TO AVOID INJURY:
622A Series
®
8
(ENGLISH)
Manual P/N: 192052171 Rev AB November 2018
11/7/18 8:55 AM
Publicité
Table des Matières
