Elica NikolaTesla Switch Prescriptions De Montage Et Mode D'emploi page 67

The LED " " goes out and the indicator count is
restarted.
Note: Repeat the operation if both filters signals are displayed
simultaneously.
Automatic operation
The product is equipped with an air quality sensor that allows
the hood to automatically set the suction speed most suitable
to the type of cooking chosen.
To activate this function:
Briefly push the Selection zone (7), the LED "
up to show that the hood is working in this mode.
Automatic hood mode with SNAP®
For information on how to make the connection between the
hood and SNAP®, see the manual supplied with SNAP® or
visit www.elica.com.
Note: SNAP® is an auxiliary extraction unit able to operate at
the same time as the hood.
To activate this function:
Briefly press the Selection Area (7), LED"
" " (22) light up to show that the hood is working in this
mode.
The suction area is equipped with a mechanical rotating
FLAP. To activate the product you have to switch on the hood
and open the flap. The hood is equipped with a sensor that,
when the suction function is activated and with the FLAP
completely closed, stops the motor automatically. The suction
function restarts only when the FLAP is reopened.
- when switching on the fan, the motor does not start if the
FLAP is closed:
be emitted every 5 seconds.
" (18) lights
- if you close the FLAP when the motor is running, the latter
stops:
be emitted every 5 seconds.
The device can also be used in combination with a
Window sensor KIT (not supplied by the manufacturer).
If the Window sensor KIT is installed (only in the case of use
in EXTRACTOR mode), air extraction will halt every time the
window in the room, on which the KIT is applied, is closed.
" (18) and LED
• The KIT must be electrically connected to the device by
qualified and specialised technical personnel.
• The KIT must be certified separately in accordance with
the safety standards for the component and its use with
the device. Installation must be carried out in accordance
with current regulations for domestic systems.
PLEASE NOTE:
• the wiring of the KIT to be connected to the device must
be part of a certified safety extra-low voltage (SELV)
circuit.
• the manufacturer of this device declines all liability for
any inconvenience, damage or fires caused by defects
and/or problems associated with the malfunction and/or
incorrect installation of the KIT.
65
Open FLAP indicator
the LED "OPEN" (23) lights up, a long beep will
the display (12) flashes
the LED "OPEN" (23) lights up, a long beep will
the display (12) flashes