Elica NikolaTesla Switch Prescriptions De Montage Et Mode D'emploi page 66

Starting the extractor:
Tap (push) the Selection area (6) to enable the hob
Extraction speed (power):
The hob features 8 suction power levels
Tap and swipe with your fingers onto the Selection zone (3):
to the right to increase the suction speed (power) (0-8);
to the left to decrease the suction speed (power) (8-0);
Suction Power Booster
The product is equipped with two additional suction speed
(power) levels (in addition to the level
- Tap and swipe with your fingers the Selection area (3) (in
addition to level ) and activate the Suction Power Booster
level 9 : remains active for 15 minutes
level 10 : remains active for 15 minutes
after that the power returns to level 8
Note: the active Suction Power Booster function is indicated
on the display (13) of the selected cooking zone with the
symbol " ".
Timer
Activation/Regulation of Timer function for the
extractor fan
• Select the extractor fan.
• Push (8) to access the Timer function (at any
speed)
• Set the duration of the Timer:
press the selector
down time
push the selector
down time
display (15) will show the countdown,
Note: the symbol " "(19) appears beside the display of the
extractor fan
When the timer has finished the count, it emits a beep (for 2
minutes; you can mute it by tapping
display (15) is flashing, showing the symbol " .
To switch-off the Timer:
• select the Selection zone (6)
• set the value of the timer to " " , via
)
, to increase the automatic shut-
, to decrease the automatic shut-
) , while the
".
Note: the function remains active if no other key is pressed
in the meantime.
Activation of filter saturation indicators
These indicators are normally deactivated
(for both the grease filter and the activated carbon filter)
To activate them, proceed as follows:
- switch on the extractor hob by means of
- with the suction motor and the cooking zones turned off,
push and hold down the Selection area (7):
the LED " " (17) turns on at low brightness
the display (14) of the extractor fan shows the letter "G" – to
proceed with the activation of the grease filter saturation
indicator –
Note : push the Selection zone (7) again to display (14) the
letter "F" and proceed the odour carbon filter
Active
- push the Selection zone (6), the LED "
switches to high brigthness, then, after 10 seconds, it
turns off and indicates that the ACTIVATION was
completed.
Deactivation of filter saturation indicators
repeat the operation described above for activation;
- the LED "
after 10 seconds, it turns off to indicate that
DEACTIVATION was completed.
Filter saturation indicator
The hood indicates when it is necessary to perform
maintenance on the filters:
Grease filter
the LED " "(17) turns on
the display (14) shows the symbol "G" (for 10 seconds from
switching on)
Activated carbon odour filter
the LED " "(17) flashes;
the display (14) shows the symbol "F" (for 10 seconds from
switching on)
Reset filter saturation
After having serviced the filters (both the grease and/or the
odour activated carbon filters) press and hold the Selection
Area (7):
64
;
" (17) switches to low brightness, then,
" (17)