Publicité
Les langues disponibles
Les langues disponibles
Pour in the detergent (devices with
ABS tank or spray bottle)
WARNING
Unsuitable detergents
Health risk, damage to the device
Use only recommended detergents. The op-
erator carries all increased risks relating to
operational safety and increased risk of acci-
dents if using other detergents.
Use only detergents free of solvents, salt and
hydrofluoric acid.
Adhere to the safety instructions stated on the
detergent packaging.
ATTENTION
Risk of damage
A cleaning solution with a temperature above
50°C can damage the device.
Only pour the cleaning solution into the deter-
gent tank or the spray bottle at a maximum
temperature of 50°C.
1. Pour in the cleaning solution.
a Devices with ABS tank: Fill up to the
MAX mark in the tank.
b Devices with ABS spray bottle: Unscrew
the spray bottle container, fill up to the
MAX mark and screw it back on. Oper-
ate the pump rod several times to build
up pressure in the spray bottle.
Illustration G
Pump rod
1
Spray lever
2
Container
3
Operation
Adjusting the inclination of the push
WARNING
Danger of accident
The device can move uncontrollably if the
push rod is adjusted while the motor is run-
ning.
Only adjust the push rod when the device is
switched off.
1. Pull the tilt adjustment lever and hold it in
position.
2. Bring the push rod into a comfortable po-
sition (about waist height).
3. Release the tilt adjustment lever.
rod
4. Move the push rod up and down slightly
until it latches into place.
Switching on the device
WARNING
Risk of injury
In the absence of ground friction, the brush
or pad can reach very high speeds. They
can be hurled away and cause injury.
Do not switch on the device when the
cleaning head is swung up.
The maximum permissible mains grid
impedance at the electrical connection
point (see Technical data) must not be
exceeded.
Contact your electricity supplier in the case
of any uncertainties regarding the mains
grid impedance at your electrical connec-
tion point.
ATTENTION
Risk of damage
The floor covering can be damaged if the
device is operated on the same spot for a
long time.
Always move the device when it is switched
on.
1. Turn the cable hook upwards, and un-
wind the mains cable completely.
2. Insert the mains plug into a mains sock-
et.
The "Mains voltage" indicator light lights
up.
3. Hold the handles firmly with both hands.
4. Press and hold the left or right unlocking
button.
The unlocking buttons can only be
pressed when the push rod is not verti-
cal.
5. Pull the ON / OFF lever on the same side
- the device starts.
6. Release the unlocking button.
7. Release the ON / OFF lever to interrupt
operation.
English
15
Publicité
