Publicité
Les langues disponibles
Les langues disponibles
Storage
DANGER
Danger of electric shock, danger of frost
Water entering the device can cause electric
shock.
Water in the device can freeze and cause
damage.
Only store the device indoors.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transport and storage.
1. Store the device indoors only.
2. Remove brush or pad / pad drive board.
ATTENTION
When the work is interrupted, do not place the
device on the brush or the pad / pad drive
board for longer than 1 hour, otherwise the
brush or the pad / pad drive board will be
damaged.
Illustration K
Care and service
WARNING
Risk of injury
The device may start up unexpectedly.
Be sure to pull the mains plug out of the sock-
et before you start working on the device.
1. Wash dirty pads at a maximum of 60 °C.
2. Clean the casing of the device with a damp
cloth and then rub dry.
3. Check the mains cable and mains plug for
damage, have damaged parts replaced by
an electrician.
Replacing the filter bag or exhaust
filter (devices with ABS suction)
1. Make sure that the mains plug is un-
plugged.
2. Unlock the lid and remove.
Illustration L
3. Move the holder anticlockwise and remove
the filter bag downwards.
4. At the latest, after changing the filter
bag 5 times: Pull out the exhaust filter
holder and open it.
5. Replace the exhaust filter.
6. Install the exhaust filter and filter bag in the
reverse order.
Troubleshooting guide
WARNING
Risk of injury
The device may start up unexpectedly.
Be sure to pull the mains plug out of the
socket before you start working on the de-
vice.
In the event of malfunctions that cannot be
remedied using the following information,
please contact customer service.
Unsatisfactory cleaning results
Replace a dirty brush or pad.
Replace a worn brush or pad.
Check the suitability of the detergent
used for the application.
Check the suitability of the brush or pad
used for the application.
The device vibrates strongly
Check the brush or pad for damage, re-
place if necessary.
Check the central position of the pad on
the pad drive board, if necessary attach
the pad centred.
Check attachment of the pad, replace
pad or pad drive board if necessary.
The brush or the pad do not turn
Check whether foreign objects block the
brush or the pad drive board, remove
foreign objects if necessary.
Plug the mains plug into the socket.
The overload protection has triggered,
let the device cool down for 30 minutes.
Devices with tank attachment kit
Discharge of cleaning solution too low
Fill the tank with cleaning solution.
Attach the pull rod to the cleaning solu-
tion lever.
Check the hose of the cleaning solution
for kinks, eliminate kinks if necessary.
Devices with ABS spray bottle
Spray system does not spray or does
not spray enough
Pour cleaning solution into the spray
bottle.
Operate the pump rod several times to
build up enough pressure.
Clean the spray nozzle.
Flush the spray system with clean water.
English
17
Publicité
