Kärcher BDP 43/400 C Mode D'emploi page 14

Control elements
Illustration A
BDP 43/400 C
1
BDP 43/400 C with tank attachment
2
kit (ABS)
BDP 43/400 C with ABS spray bottle
3
BDP 43/400 C with ABS suction
4
Cleaning head
5
Type plate
6
Mains connection cable with mains plug
7
Cable hook, rotating
8
Strain relief
9
Thrust rod
10
Pull rod*
11
Tank*
12
Hose for cleaning solution*
13
Pump rod**
14
Spray lever**
15
Spray bottle**
16
Brush or pad drive board / pad
17
Spray nozzle**
18
Indicator light for mains voltage
19
Handle
20
Suction switch ON / OFF***
21
Suction warning light***
22
Suction mains plug***
23
Lever for cleaning solution
24
ON/OFF lever
25
Unlocking button
26
Tilt adjustment lever
27
Suction skirt***
28
Suction hose***
29
Exhaust filter***
30
Dust bag***
31
Suction unit***
32
Suction power regulation slider***
33
* only with ABS tank
** only with ABS spray bottle
*** only with ABS suction
14
Mounting the push rod
1. Align the holes in the push rod with the
holes on the cleaning head.
Illustration B
Thrust rod
1
Screws (3 pieces)
2
Cleaning head
3
2. Insert the screws with washers, and tight-
en using stop nuts with washers (tighten-
ing torque: 25 Nm).
Note
Do not overtighten the stop nuts. The push
rod must not jam in the mount, and must be til-
table without effort after unlocking.
3. Insert the plug into the socket on the clean-
ing head.
Illustration C
Plug
1
Bar cover
2
Screws(2 pieces)
3
4. Install the bar cover and tighten using
screws with washers.
5. Attach the mains cable to the strain relief
from below as shown.
Illustration D
Mains cable
1
Strain relief
2
Initial startup
Attaching the brush or the pad drive
1. Select the brush suitable for the cleaning
task or the corresponding pad with the pad
drive board.
2. Make sure that the mains plug is un-
plugged.
3. Tilt the device backwards and place it
carefully on the handle.
Illustration E
4. Place the brush or the pad drive board on
the device and turn it 45° anticlockwise.
Illustration F
5. After installing a pad drive board: Centre
and press the pad onto the pad drive
board.
6. Erect the device.
English
Installation
board with pad